|Shaft support rails|
Fiberglide bearings are characterised by their high load-bearing capacity and dry-running properties. The bearings have a steel, bronze or stainless steel outer jacket and are available as a thin-walled model or thick-walled, turned model. The wearing surface is formed by a woven fibreglass and PTFE material that is glued to the inside. Fiberglide bearings are available as cylindrical bearings (both thin-walled and thick-walled), collar bearings (thick-walled only) and thrust washers. Different models such as spherical self-adjusting bearings are also possible.
THN has a limited standard range of Fiberglide bearings in various sizes and models. The standard range comprises mainly thin-walled, rolled (P-A1) bearings, but also a number of thick-walled, turned bushings with (P-A8) and without a collar (P-A7). There is also a standard range of thrust washers with steel jacket and lined on one side (P-A3), or with a wearing surface on both sides and an epoxy strengthening layer (P-C3).
The most important properties of Fiberglide bearings are:
The suitability of Fiberglide bearings is shown below:
Permitted loads for the Fiberglide bearings are as follows:
|Max. PV value||N/mm²·m/s||0,67 *|
|Max. load P static||N/mm²||210|
|Max. load P dynamic||N/mm²||140|
|Max. running speed V||m/s||0,17|
|Maximum temperature||°C||+ 150|
|Minimum temperature||°C||- 160|
* A momentary PV value of 2.16 N/mm²·m/s is allowed.
© Copyright 2015 Technische Handelsonderneming Nederland b.v.